- 4 black steel 1 ⅝”, 7 ½’ finished height fence support posts
- 4 caps for posts (installed on posts already)
- 4 no-dig ground sleeves for posts
- 4 locking set screws installed in sleeves (makes posts removable or permanent; patent pending)
- 8 black steel 1 ⅜”, 89" framing posts
- 1 7 ½” x 100” roll of Critterfence Steel Wire 1" x 1" Black PVC coated galvanized steel
- 1 10" 120-lb breaking strength black fence ties (100pk)
- 1 12" kinked galvanized ground stakes (30pk)
- 4 1 ⅜” to 1 ⅜” black end clamp hardware
- 4 1 ⅝” to 1 ⅜” black end clamp hardware
- 4 1 ⅝” to 1 ⅜” black center clamp hardware
- 25 black self-tapping screws
- 1 fence instruction manual
Installed rear extension kit dimensions:
- 7 ½’ wide by 15’ long
- 7 ½’ tall outside and 7’ inside overhead clearance
These add-on kits will only work in conjunction with another kit (Fence Kit With Top 4 in this case). Some of the hardware in your original kit will be reused or replaced with new hardware from this kit.
Notes:
- Posts are round galvanized inside and out, then black powder-coated. No-dig sleeves are heavily galvanized inside and out for extreme long-life. Ground sleeves go into the ground 30 inches. The finished height of the fence posts is the height above the ground. For example, an 8-foot finished height means the final post will be 8 feet above the ground once the sleeve is in the dirt and the post has been installed into the sleeve.
- All posts with ground sleeves can be installed permanently or made removable. No-dig ground sleeves get driven into the ground with a sledgehammer. The posts then slide inside the sleeve and lock in with a locking set screw (patent pending). To remove posts for seasonal protection or to move your fence, first, cut the fence ties holding the fence to the posts. Then roll up the fencing and slide the post up out of the sleeve. To make posts permanent, tighten the locking set screw in each sleeve to prevent the post from spinning or coming up out of the post.
- For rocky or heavily compacted ground, we suggest using a San Angelo digging bar to pilot the hole for sleeves (instructions with kit). You can also use a powered or hammer drill with our custom sleeve auger bit.
- These fence kits are designed to be installed on level and flat areas. If you're installing this over an area that has a slope or is pitched in one direction, some cutting or modifying of the fence post height will be required. This may make the overall height of your fence shorter. For example, if you are installing in an area that slopes from higher to lower, to make the enclosure level, you would cut the front posts 1 inch, the middle posts ½ inch, and leave the rear posts.
- These fence kits start with approximately 7 feet of overhead clearance. The side posts are 7 ½ feet out of the ground, but some space is needed for the framing and side bracing. Access gates are available separately; select 7-foot-tall gates or shorter for proper installed clearance.
